how to replace a tongue and groove porch floor

How do you install tongue and groove flooring on a porch?

Step 1: Remove Tongue and Groove Deck Boards. Take a pry bar to remove the nails and screws that hold the tongue and groove deck boards in place. Step 2: Secure the Deck Posts. You will need a level to check the deck posts in order to make sure that they are secure. Step 3: Replace Tongue and Groove Deck Boards.

Get Price

Repair for an Old Wooden Porch - Extreme How To

For this repair project we milled interlocking tongue-and-groove boards from treated lumber to replace the original rotted porch boards. I decided to replace the entire side of porch flooring with the exception of a roughly 4-ft. span that I could tell was the original porch flooring from when the house was built in 1880.

Get Price

Front Porch Wood Flooring - Ask the Builder

You will pull part of the tongue off the piece of lumber where it crosses over each floor joist below the porch flooring. After this piece of lumber is removed, the only remaining step is to remove the slivers of the tongue that are pinned in place by the nails used to fasten the original tongue and groove strip of lumber to the porch floor joists.

Get Price

How to Remove Tongue and Groove Flooring without Causing Any .

#geekstreet #diy #removeflooringHow to remove tounge and groove flooring without damaging ️ ️🛒 www.amazon.co.uk/shop/geekstreet🛒 h.

Get Price

How to Remove and Replace Tongue and Groove Floor Boards .

How to Install Tongue and Groove Flooring in 15 Steps Measure and mark a new floorboard to fit into the floor. Adjust a circular saw for a slight 5-degree bevel, then crosscut the new floorboard to length. Apply construction adhesive to the subfloor.

Get Price

Replacing A Damaged Tongue-And-Groove Board In 7 Easy Steps .

Continue fitting in the tongue with the adjacent board until you reach the flooring. Step Seven: Using a padded block and soft cloth, tap the new board in place. Add finishing nails to the top and bottom of the new Tongue-and-Groove board. Make sure to fill in the nail holes with wood putty and finish for appearance.

Get Price

How to Repair Tongue and Groove Porch Flooring | DoItYourself.com

In order to get your damaged board removed, you are going to need to get the edge of your chisel set up along the edge of the board. Tap inward on the edge and move it towards the middle cut out with a hammer. Get the edges of this board knocked inward on either side with your tongue and groove fittings of each of the adjacent boards.

Get Price

How to Replace Sections of a Tongue & Groove Hardwood Floor .

Tongue-and-groove flooring uses a system of interlocking edges – tongues and grooves – to stay in place with few nails. When floor planks get split or warped, replace them for aesthetic .

Get Price

How to Replace Damaged Tongue and Groove Boards .

After you have prepared the space, you need to install a replacement board. In order to do this, you will need to remove the tongue from the board. Lay the board on the ground and use your circular saw to cut the tongue off of it. This will allow you to put the board down into the hole in the floor.

Get Price

How To Replace Tongue and Groove Porch Boards - YouTube

Rotten porch board are a big issue with historic homes. In the video we will show techniques to replace tongue and groove porch boards both in the middle an.

Get Price

How to Install Tongue-and-Groove Porch Flooring | how-tos | DIY

From the wall, measure one board-width and snap a chalk-line. Lock the boards into place, then face-nail the first row of boards, then use a pneumatic flooring nailer to nail each nail into the tongue of the board.

Get Price

Product Details

Product List