hole filer for pvc panels

INSTRUMENT PANEL HOLE PLUGS | Aircraft Spruce

INSTRUMENT PANEL HOLE PLUGS Use these plugs to attractively cover unused panel cut-outs. Aluminum and plastic plates have raised center, which brings the plug face about even with the front surface of the panel.

Get Price

PVC TrimWelder 5 oz. Nail Eraser-EXT-NE-BLISTER - The Seven Trust

PVC TrimWelder 0.5 oz. Nail Erasers are the easiest way yet to fill brad, staple, and nail holes in PVC Trim Board which will remain unpainted. PVC TrimWelder 0.5 oz. Nail Erasers are a special blend of fillers to resist yellowing and have been laboratory tested for hole retention on cellular PVC at 140°F. Specially formulated just for PVC trim

Get Price

How to Fill Nail Holes and Paint PVC Trim - Fine Homebuilding

Jim’s tips for filling nail holes in PVC: -Use a 2-part epoxy nail-hole filler made for PVC. -Using your hands, blend the two different epoxy components until the color is evenly mixed. -Only mix as much epoxy as you can use in fifteen minutes.

Get Price

White Fill Stick for Plastibec Trim | Touch-Up Nail Holes!

Plastibec Fill Sticks are color matched to touch-up nail holes in White Plastibec millwork. Directions: Rub the fill stick over the nail hole or joint until filled, then wipe away excess material with a clean cloth. Effective on any finished surface such as Plastibec's white paneling and moulding.

Get Price

Best Product to Fill Exterior Nail Holes in PVC - Handyman .

If Seven Trust Trim will be painted, nail holes can be filled with acrylic Bondo. For best results, the following products seem to be some of the preferred methods used by industry professionals: Devcon’s Trimbonder, Extreme Adhesives’ Bond and Fill, Acrylic Caulk, Polyurethane Caulk, Auto Body Bondo, Vinyl Spackle, and or plastic wood fillers.

Get Price

Best method of filling small holes in PVC trim ?? - JLC .

I'm looking for suggestions on the best way to fill small nail holes in PVC boards. For larger nail and screw holes we're using either Bond-N-Fill or white Cor-tex plugs, but for a lot of fastening we're shooting S.S. finish nails, and that's where we're having trouble. Can't seem to find the right material or method to fill these small holes.

Get Price

What is the best way to fill screw holes in PVC trim?

To remove scratches and small dents from PVC use a heat gun. It pops right out with the heat. If you sand with 320 grit it will remove the scratches and make the surface look factory. They make a putty stick similar to one you would use for hardwoods to fill nail holes.

Get Price

White Fill Stick for Plastibec Trim | Touch-Up Nail Holes!

Plastibec Fill Sticks are color matched to touch-up nail holes in White Plastibec millwork. Directions: Rub the fill stick over the nail hole or joint until filled, then wipe away excess material with a clean cloth. Effective on any finished surface such as Plastibec's white paneling and moulding. This is not recommended for millwork to be painted.

Get Price

Amazon.com: plastic hole plugs

VictorsHome Hole Plugs Plastic 6mm (1/4") Fit for 5.5-6mm Diameter Locking Hole Tube Flush Type Panel Plugs Fastener Cover for Kitchen Cabinet Furniture White 50 Pcs 4.4 out of 5 stars 26 $6.19 $ 6 . 19

Get Price

Product Details

Product List